Nissan Juke Service and Repair Manual : Ambient sensor
Removal and Installation
REMOVAL
1. Remove bumper fascia assembly. Refer to EXT-13, "Removal and Installation".
2. Disengage fixing pawl, and then remove ambient sensor (1) from air guide RH.
: Pawl
3. Disconnect ambient sensor connector (2), and then remove ambient sensor.
INSTALLATION Install in the reverse order of removal.
A/C auto AMP.
Removal and Installation
REMOVAL
1. Remove audio unit. Refer to AV-38, "Removal and Installation".
2. Remove inside key antenna (instrument center). Refer to DLK-188, "INSTRUMENT
C ...
In-vehicle sensor
Removal and Installation
REMOVAL
1. Remove instrument lower panel (LH/RH). Refer to IP-13, "Removal and
Installation".
2. Remove fixing screw, and then remove in-vehicle sensor from ins ...
Other materials:
Suspension arm
Exploded View
1. Rear suspension member
2. Adjusting bolt
3. Upper link
4. Eccentric disk
5. Lower link
6. Suspension arm bracket
7. Suspension arm
: Vehicle front
: Always replace after every
disassembly.
: N·m (kg-m, ft-lb)
Removal and Installation
REMOVAL
1. Remove tires. Re ...
Radiator core support
HR16DE
HR16DE : Exploded View
1. Radiator core support upper
2. Air guide RH (MT models)
3. Radiator core support lower
4. Air guide LH
5. Air guide (upper)
6. Air guide LH (CVT models)
7. Air guide RH (CVT models)
: N·m (kg-m, ft-lb)
HR16DE : Removal and Installation
RADIATOR CORE ...
B2191 difference of key
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected?
YES >> Refer to SEC-203, "Diagnosis Procedure".
N ...
