Ambient sensor

Removal and Installation REMOVAL 1. Remove bumper fascia assembly. Refer to EXT-13, "Removal and Installation". 2. Disengage fixing pawl, and then remove ambient sensor (1) from air gu ...

Sunload sensor

Removal and Installation REMOVAL 1. Remove switch panel. Refer to IP-13, "Removal and Installation". 2. Disconnect sunload sensor connector, and then remove sunload sensor. INSTALLATIO ...

Other materials:

B257B, B257C ambient sensor
DTC Logic DTC DETECTION LOGIC NOTE: • If DTC is displayed along with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to HAC- 275, "DTC Logic". • If DTC is displayed along with DTC U1010, first perform the trouble diagnosis for DTC U1010. HAC-276, "DTC ...

Air cleaner and air duct
Exploded View 1. Mass air flow sensor 2. Gasket 3. Clamp 4. Air duct (suction side) 5. Clamp 6. Air cleaner cover assembly 7. Mounting rubber 8. Air cleaner filter 9. Air cleaner body assembly 10. Air duct with resonator 11. Grommet 12. Air duct (duct side) 13. Grommet 14. B ...

Engine oil
Inspection OIL LEVEL AND MUDDINESS • Before starting the engine, check the oil level placing vehicle horizontally. If the engine is already started, stop it and allow 10 minutes before checking. • Make sure the oil level is within the range shown in the figure. • If it is out of rang ...