Nissan Juke Service and Repair Manual : Sunload sensor

Removal and Installation

REMOVAL

1. Remove switch panel. Refer to IP-13, "Removal and Installation".

2. Disconnect sunload sensor connector, and then remove sunload sensor.

INSTALLATION

Install in the reverse order of removal.

    In-vehicle sensor
    Removal and Installation REMOVAL 1. Remove instrument lower panel (LH/RH). Refer to IP-13, "Removal and Installation". 2. Remove fixing screw, and then remove in-vehicle sensor from ins ...

    Intake sensor
    Exploded View Refer to HA-97, "Exploded View (Automatic Air Conditioning)". Removal and Installation REMOVAL 1. Remove evaporator assembly. Refer to HA-115, "EVAPORATOR : Removal an ...

    Other materials:

    Vehicle Dynamic Control (VDC) off switch
    The vehicle should be driven with the Vehicle Dynamic Control (VDC) system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to reduce wheel spin. The engine speed will be reduced even if the accelerator is depressed to the floo ...

    P2119 electric throttle control function
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK INTERMITTENT INCIDENT Refer to GI-42, "Intermittent Incident". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace. 2.REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR 1. Replace electric t ...

    B2602 shift position
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2602 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B2602 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, "D ...