Nissan Juke Service and Repair Manual : Heater & Air Conditioning Control System Type 1
- How to use this manual
- Precaution
- System description
- Component parts
- System
- Operation
- Diagnosis system (A/C auto AMP.)
- Diagnosis system (BCM) (with intelligent key system)
- Diagnosis system (BCM) (without intelligent key system)
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- U1000 can comm circuit
- U1010 control unit (CAN)
- B2578, B2579 In-vehicle sensor
- B257B, B257C ambient sensor
- B2581, B2582 intake sensor
- B2630, B2631 sunload sensor
- B27A0, B27A1 intake door motor
- B27A2, B27A3, B27A4, B27A5 air mix door motor
- B27A6, B27A7, B27A8, B27A9 mode door motor
- Power supply and ground circuit
- A/C on signal
- Blower fan on signal
- Blower motor
- Magnet clutch
- Symptom diagnosis
- Removal and installation
Service data and specifications (SDS
Compressor
Lubricant
Refrigerant
Engine Idling Speed
Refer to EC-449, "Idle Speed".
Belt Tension
Refer to EM-20, "Checking". ...
How to use this manual
APPLICATION NOTICE
Information
Check the vehicle type to use the service information in this section.
...
Other materials:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG� and “SEAT BELT PRE-TENSIONER�,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front passenger for certain
types of collision. Information necessary to service the system safely is
...
P0840 transmission fluid pressure SEN/SW A
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
NOTE:
If “DTC CONFIRMATION PROCEDURE� has been previously performed, always turn
ignition switch
OFF and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the ...
Door switch
Component Function Check
1.CHECK FUNCTION
1. Select “DOOR LOCK� of “BCM� using CONSULT-III.
2. Select “DOOR SW-DR�, “DOOR SW-AS�, “DOOR SW-RL�, “DOOR SW-RR�, “DOOR SW-BK�
in “DATA
MONITOR� mode.
3. Check that the function operates normally according to the fo ...
