Nissan Juke Service and Repair Manual : Door motor starting position reset

Description

• Reset signal is transmitted from A/C auto amp. to air mix door motor and mode door motor. Starting position reset can be performed.

NOTE

:
During reset, DEF switch indicator blinks.

• When air mix door motor or mode door motor is removed and installed, always perform door motor starting position reset.

Work Procedure

1.PERFORM DOOR MOTOR STARTING POSITION RESET

1. Turn ignition switch ON.With CONSULT-III


1. Turn ignition switch ON.

2. Select “Door Motor Starting Position Reset” in “ACTIVE TEST” mode of “HVAC” using CONSULT-III.

3. Touch “Start” and wait a few seconds.

4. Make sure the “COMPLETED” is displayed on CONSULT-III screen.

>> INSPECTION END

    System setting
    Temperature Setting Trimmer DESCRIPTION If the temperature felt by the customer is different from the air flow temperature controlled by the temperature setting, the A/C auto amp. control tempera ...

    Other materials:

    ASCD brake switch
    Component Function Check 1.CHECK ASCD BRAKE SWITCH FUNCTION With CONSULT-III 1. Turn ignition switch ON. 2. Select “ENGINE” using CONSULT-III. 3. Select “BRAKE SW1” in “DATA MONITOR” mode. 4. Check “BRAKE SW1” indication under the following conditions. Without CONSULT-III 1 ...

    Removal and installation
    COMBINATION METER Exploded View REMOVAL Refer to IP-12, "Exploded View". DISASSEMBLY 1. Front cover 2. Unified meter control unit Removal and Installation REMOVAL 1. Remove cluster lid A. Refer to IP-13, "Removal and Installation". 2. Remove the mounting screws of ...

    B2578, B2579 In-vehicle sensor
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC is displayed along with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to HAC- 51, "DTC Logic". • If DTC is displayed along with DTC U1010, first perform the trouble diagnosis for DTC U1010. HAC-52, "DTC L ...