Nissan Juke Service and Repair Manual : DTC/circuit diagnosis
- U1000 can comm circuit
- U1010 control unit (CAN)
- B2578, B2579 In-vehicle sensor
- B257B, B257C ambient sensor
- B2581, B2582 intake sensor
- B2630, B2631 sunload sensor
- B27A0, B27A1 intake door motor
- B27A2, B27A3, B27A4, B27A5 air mix door motor
- B27A6, B27A7, B27A8, B27A9 mode door motor
- Power supply and ground circuit
- A/C on signal
- Blower fan on signal
- Blower motor
- Magnet clutch
Door motor starting position reset
Description
• Reset signal is transmitted from A/C auto amp. to air mix door motor and
mode door motor. Starting position
reset can be performed.
NOTE:
During reset, DEF switch indicator bli ...
U1000 can comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real time
applications. It is an on-board multiplex
communication line with high data communication speed and excellent ...
Other materials:
For frontal collision : When SRS is activated in a collision
CAUTION:
Due to varying models and option levels, not all parts listed in the chart below
apply to all vehicles.
WORK PROCEDURE
1. Before performing any of the following steps, ensure that all vehicle body
and structural repairs have been
completed.
2. Replace the diagnosis sensor unit.
...
LAN System can system (type 4)
DTC/CIRCUIT DIAGNOSIS
Main line between IPDM-E and DLC circuit
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (connector s ...
Special Service Tool
HFC-134a (R-134a) Service Tool and Equipment
• Never mix HFC-134a (R-134a) refrigerant and/or its specified lubricant with
CFC-12 (R-12) refrigerant and/
or its lubricant.
• Separate and non-interchangeable service equipment must be used for handling
each type of refrigerant/
lubricant.
...
