Nissan Juke Service and Repair Manual : U1010 control unit (CAN)

Description

Initial diagnosis of A/C auto amp.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.With CONSULT-III


1. Turn ignition switch ON.

2. Select “Self Diagnostic Result” mode of “HVAC” using CONSULT-III.

3. Check DTC.

Is DTC detected? YES >> Refer to HAC-52, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.REPLACE A/C AUTO AMP.

Replace A/C auto amp. Refer to HAC-91, "Removal and Installation".

>> INSPECTION END

    U1000 can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-board multiplex communication line with high data communication speed and excellent ...

    B2578, B2579 In-vehicle sensor
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC is displayed along with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to HAC- 51, "DTC Logic". • If DTC is displ ...

    Other materials:

    Front disc brake
    Brake pad : Inspection and Adjustment INSPECTION Check brake pad wear thickness from an inspection hole on cylinder body. Check using a scale if necessary.Wear thickness : Refer to BR-137, "Front Disc Brake". ADJUSTMENT Burnish contact surfaces between disc rotor and brake pads ac ...

    P1197 out of gas
    Description This diagnosis result is detected when the fuel level of the fuel tank is extremely low and the engine does not run normally. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition ...

    P183B solenoid power supply
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...