Nissan Juke Service and Repair Manual : Auto operation does not operate but manual operate normally (driver side)

Nissan Juke Service and Repair Manual / Power Window Control System / Symptom diagnosis / Auto operation does not operate but manual operate normally (driver side)

Diagnosis Procedure

1.PERFORM INITIALIZATION PROCEDURE

Initialization procedure is executed and operation is confirmed.

Refer to PWC-16, "Work Procedure".

Is the inspection result normal? YES >> INSPECTION END

NO >> GO TO 2.

2.CHECK ENCODER CIRCUIT

Check encoder circuit.

Refer to PWC-30, "Component Function Check".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.CONFIRM THE OPERATION

Confirm the operation again.

Is the result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> GO TO 1.

    Driver side power window does not operate
    Diagnosis Procedure 1.CHECK FRONT POWER WINDOW MOTOR (DRIVER SIDE) Check front power window motor (driver side). Refer to PWC-26, "DRIVER SIDE : Component Function Check". Is the ins ...

    Anti-pinch system does not operate normally (driver side)
    Diagnosis Procedure 1.CHECK POWER WINDOW AUTO OPERATION Check AUTO operation when anti-pinch function does not operate. Is the inspection result normal? YES >> GO TO 2. NO >> Refe ...

    Other materials:

    Refrigerant pressure sensor
    Component Function Check 1.CHECK REFRIGERANT PRESSURE SENSOR OVERALL FUNCTION 1. Start engine and warm it up to normal operating temperature. 2. Turn A/C switch and blower fan switch ON. 3. Check the voltage between ECM harness connector and ground.] Is the inspection result normal? YES > ...

    Diagnosis system (BCM) (without intelligent key system)
    Description Air conditioning system performs self-diagnosis, operation check, function diagnosis, and various settings using diagnosis function of each control unit. Common item : consult-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN ...

    Hood switch
    Component Function Check 1.CHECK FUNCTION 1. Select “HOOD SW” in “Data Monitor” mode of “IPDM E/R” using CONSULT-III. 2. Check “HOOD SW” indication under the following condition. Is the indication normal? YES >> Hood switch is OK. NO >> Go to SEC-155, "Diag ...