Nissan Juke Service and Repair Manual : Controller

Removal and Installation

REMOVAL

Remove multi display unit. Refer to IP-13, "Removal and Installation".

INSTALLATION

Install in the reverse order of removal.

    A/C auto AMP.
    Removal and Installation REMOVAL 1. Remove audio unit. Refer to AV-38, "Removal and Installation". 2. Remove inside key antenna (instrument center). Refer to DLK-188, "INSTRUMENT C ...

    Other materials:

    Fuel filter
    Exploded View Removal and Installation REMOVAL (RHD) 1. Remove quick connectors in the following procedures. • Pinch quick connector square-parts with your fingers, and pull out the quick connector by hand. • If quick connector and tube on vehicle are stuck, push and pull several ti ...

    P0340 CMP sensor (phase)
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0340 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643. Refer to EC-686, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disc
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...