A/C auto AMP.

Reference Value CONSULT-III DATA MONITOR REFERENCE VALUES *: “DUTY” is displayed, but voltage is indicated. Or unit is not displayed but unit is (V). TERMINAL LAYOUT PHYSICAL VALUES Fai ...

Wiring diagram

AUTOMATIC AIR CONDITIONING SYSTEM Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12 ...

Other materials:

A/C control
Exploded View 1. Intake door cable 2. Mode door cable 3. A/C control 4. Air mix door cable 5. Intake door lever knob A. To mode door link B. To intake door link C. To air mix door link Removal and Installation REMOVAL 1. Remove A/C finisher. Refer to IP-13, "Removal and Install ...

P183A coupling temperature sensor right
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

B1049, B1054 driver air bag module
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...