Nissan Juke Service and Repair Manual : Diagnosis system (BCM) (with intelligent key system)

Common item : consult-III Function (BCM - common item)

APPLICATION ITEM

CONSULT-III performs the following functions via CAN communication with BCM.

SYSTEM APPLICATION


SYSTEM APPLICATION

BCM can perform the following functions for each system.

NOTE

:
It can perform the diagnosis modes except the following for all sub system selection items.

NOTE:


NOTE

:
• *1: This item is displayed, but not used.

• *2: For models with automatic A/C, this diagnosis mode is not used.

FREEZE FRAME DATA (FFD)

The BCM records the following vehicle condition at the time a particular DTC is detected, and displays on CONSULT-III.

Air conditioner : consult-III Function (BCM - AIR CONDITIONER) (Automatic


Air conditioner : consult-III Function (BCM - AIR CONDITIONER) (Automatic A/C 4WD Models)

DATA MONITOR

Display Item List

Diagnosis system (BCM) (without intelligent key system)


    Diagnosis system (A/C auto AMP.)
    Description Air conditioning system performs self-diagnosis, operation check, function diagnosis, and various settings using diagnosis function of each control unit. CONSULT-III Function CONSU ...

    Diagnosis system (BCM) (without intelligent key system)
    Common item : consult-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the follow ...

    Other materials:

    P1701 TCM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION 1. S ...

    P0172 fuel injection system function
    DTC Logic DTC DETECTION LOGIC With the Air/Fuel Mixture Ratio Self-Learning Control, the actual mixture ratio can be brought closely to the theoretical mixture ratio based on the mixture ratio feedback signal from the A/F sensor 1. The ECM calculates the necessary compensation to correct the ...

    P158A ECM
    DTC Logic *: Since this DTC is detected when G sensor calibration is incomplete, there is not replacement parts. 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition swit ...