Nissan Juke Service and Repair Manual : The ambient temperature display is incorrect

Description

• The displayed ambient air temperature is higher than the actual temperature.

• The displayed ambient air temperature is lower than the actual temperature.

Diagnosis Procedure

NOTE

:
Check that the symptom is not applicable to the normal operating condition before starting diagnosis. Refer to MWI-68, "INFORMATION DISPLAY : Description".

1.CHECK AMBIENT SENSOR SIGNAL CIRCUIT

Check the ambient sensor signal circuit. Refer to HAC-56, "Diagnosis Procedure" (4WD models) or HAC-146, "Diagnosis Procedure" (2WD models).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair harness or connector.

2.CHECK A/C AUTO AMP./PTC HEATER CONTROL UNIT CONNECTION

RECOGNITION SIGNAL CIRCUIT

Check the A/C auto amp./PTC heater control unit connection recognition signal circuit. Refer to MWI-62, "Diagnosis Procedure" (A/C auto amp.) or MWI-63, "Diagnosis Procedure" (PTC heater control unit).

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair harness or connector.

3.CHECK AMBIENT SENSOR

Perform the part check for the ambient sensor. Refer to HAC-57, "Component Inspection" (4WD models) or HAC-147, "Component Inspection" (2WD models).

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation".

NO >> Replace ambient sensor. Refer to HAC-92, "Removal and Installation" (4WD models) or HAC- 189, "Removal and Installation" (2WD models).

    The oil pressure warning lamp does not turn off
    Description The oil pressure warning lamp remains illuminated while the engine is running (normal oil pressure). Diagnosis Procedure 1.CHECK OIL PRESSURE WARNING LAMP Perform auto active test. R ...

    Normal operating condition
    INFORMATION DISPLAY INFORMATION DISPLAY : Description AMBIENT TEMPERATURE The displayed ambient temperature on the information display may differ from the actual temperature because it is a corr ...

    Other materials:

    U1000 can comm circuit
    Description CAN (Controller Area Network) is a serial communication system for real time application. It is an on-vehicle multiplex communication system with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto vehicles, and ea ...

    Brake pedal
    Inspection and Adjustment INSPECTION Brake Pedal Height Check the height (H1) between the dash lower panel (1) and the brake pedal upper surface. H1 : Refer to BR-70, "Brake Pedal". CAUTION: Remove the floor trim. Stop Lamp Switch Check the clearance (C) among the brake pedal le ...

    Refrigerant pressure sensor
    Component Function Check 1.CHECK REFRIGERANT PRESSURE SENSOR OVERALL FUNCTION 1. Start engine and warm it up to normal operating temperature. 2. Turn A/C switch and blower fan switch ON. 3. Check the voltage between ECM harness connector and ground. Is the inspection result normal? YES >& ...