Nissan Juke Service and Repair Manual : Normal operating condition

INFORMATION DISPLAY

INFORMATION DISPLAY : Description

AMBIENT TEMPERATURE

The displayed ambient temperature on the information display may differ from the actual temperature because it is a corrected value calculated from the ambient sensor signal by the combination meter. Refer to MWI-16, "INFORMATION DISPLAY : System Description" for details on the correction process.

DISTANCE TO EMPTY

The calculated distance to empty may differ from the actual distance to empty if the refueling amount is approximately 15 Imp gal) or less. This is because the refuel control (moves the fuel gauge (4 US gal, 3-1/4
Imp gal) or less. This is because the refuel control (moves the fuel gauge needle quicker than normal judging that the driver is refueling the vehicle) is not performing.

    The ambient temperature display is incorrect
    Description • The displayed ambient air temperature is higher than the actual temperature. • The displayed ambient air temperature is lower than the actual temperature. Diagnosis Procedure N ...

    Removal and installation
    COMBINATION METER Exploded View REMOVAL Refer to IP-12, "Exploded View". DISASSEMBLY 1. Front cover 2. Unified meter control unit Removal and Installation REMOVAL 1. Remove clu ...

    Other materials:

    P1217 engine over temperature
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P1217 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX. • If DTC P1217 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. Refer to EC-304, "DTC Logic". If the cooling fan ...

    Catalyst
    2WD 2WD : Exploded View 1. A/F sensor 1 2. Catalyst convertor shroud upper 3. Gasket 4. Catalyst 5. Catalyst convertor support bracket rear 6. Catalyst convertor bracket (RH) A. To exhaust system : Engine front : N·m (kg-m, ft-lb) : N·m (kg-m, in-lb) : Always replace after every ...

    L terminal circuit (open)
    Description The “L” terminal circuit controls the charge warning lamp. The charge warning lamp illuminates when the ignition switch is set to ON or START. When the alternator is providing sufficient voltage with the engine running, the charge warning lamp will go off. If the charge warnin ...