Nissan Juke Service and Repair Manual : Symptom diagnosis
- The fuel gauge indicator does not operate
- The oil pressure warning lamp does not turn on
- The oil pressure warning lamp does not turn off
- The ambient temperature display is incorrect
- Normal operating condition
PTC heater control unit connection recognition signal
circuit
Diagnosis Procedure
1.CHECK PTC HEATER CONTROL UNIT CONNECTION RECOGNITION SIGNAL
1. Turn ignition switch ON.
2. Check voltage between combination meter harness connector and ground.
Is the insp ...
The fuel gauge indicator does not operate
Description
Fuel gauge will not indicate from a certain position.
Diagnosis Procedure
1.CHECK COMBINATION METER OUTPUT SIGNAL
1. Connect CONSULT-III.
2. Select the “Data Monitor” for the “M ...
Other materials:
Wheels
Wash the wheels when washing the vehicle to maintain their appearance.
• Clean the inner side of the wheels when the wheel is changed or the underside
of the vehicle is washed.
• Inspect wheel rims regularly for dents or corrosion. Such damage may cause loss
of pressure or poor seal at the ...
P062B ECM
Description
This DTC is detected when the ECM-integrated injector driver unit has a
malfunction. For injector driver unit,
refer to EC-31, "ECM".
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
1. Turn ignition switch OFF and wait at least 10 seconds.
...
System malfunction
If the Rear Automatic Braking (RAB) system encounters a technical fault, it will automatically deactivate to prevent unpredictable behavior. In such cases, the RAB warning light will illuminate on your instrument cluster, and the "Malfunction: See Owner's Manual" warning message will appear in the N ...
