Nissan Juke Service and Repair Manual : The fuel gauge indicator does not operate
Description
Fuel gauge will not indicate from a certain position.
Diagnosis Procedure
1.CHECK COMBINATION METER OUTPUT SIGNAL
1. Connect CONSULT-III.
2. Select the “Data Monitor” for the “METER/M&A” and compare the “FUEL METER” monitor value with the fuel gauge reading on the combination meter. Refer to MWI-52, "Component Function Check".
Does monitor value match fuel gauge reading? YES >> GO TO 2.
NO >> Replace combination meter. Refer to MWI-69, "Removal and Installation".
2.CHECK FUEL LEVEL SENSOR SIGNAL CIRCUIT
Check the fuel level sensor signal circuit. Refer to MWI-52, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair harness or connector.
3.CHECK FUEL LEVEL SENSOR UNIT
Perform a unit check for the fuel level sensor unit. Refer to MWI-54, "Component Inspection".
Is the inspection result normal? YES >> GO TO 4.
NO >> Replace fuel level sensor unit (main or sub). Refer to FL-6, "2WD : Removal and Installation" (MR16DDT) (2WD), FL-11, "4WD : Removal and Installation" (MR16DDT) (4WD), FL-33, "Removal and Installation" (HR16DE), or FL-51, "Removal and Installation" (K9K).
4.CHECK FLOAT INTERFERENCE
Check that the float arm interferes with or binds to other components in the fuel tank.
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation".
NO >> Repair or replace malfunctioning parts.
The oil pressure warning lamp does not turn on
Description
The oil pressure warning lamp stays off when the ignition switch is turned
ON.
Diagnosis Procedure
1.CHECK OIL PRESSURE WARNING LAMP
Perform auto active test. Refer to PCS-12, " ...
Other materials:
U1000 can comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellent error
detection ability. Many electronic
control units are equipped onto a vehicle, and each co ...
PTC heater control unit
Reference Value
CONSULT-III DATA MONITOR REFERENCE VALUES
TERMINAL LAYOUT
PHYSICAL VALUES
DTC Index
...
Li-ion battery warmer
For models equipped with a 40 kWh battery
CAUTION
The Li-ion battery warmer system is designed to maintain optimal battery health; however, it will not operate if the available battery charge is approximately 15% or less and the vehicle is not connected to a charging source. To protect the ...
