Nissan Juke Service and Repair Manual : Meter, Warning Lamp & Indicator
- Precaution
- System description
- Ecu diagnosis information
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- U1000 can comm circuit
- U1010 control unit (can)
- B2205 vehicle speed
- B2267 engine speed
- B2268 water temp
- B2321, B2322 oil level sensor
- Power supply and ground circuit
- Fuel level sensor signal circuit
- Oil pressure switch signal circuit
- Seat belt buckle switch signal circuit (driver side)
- Seat belt buckle switch signal circuit (passenger side)
- A/C auto AMP. Connection recognition signal circuit
- PTC heater control unit connection recognition signal circuit
- Symptom diagnosis
- The fuel gauge indicator does not operate
- The oil pressure warning lamp does not turn on
- The oil pressure warning lamp does not turn off
- The ambient temperature display is incorrect
- Normal operating condition
- Removal and installation
Service data and specifications (SDS)
Battery
...
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...
Other materials:
Automatic air conditioner (with Integrated Control System)
1. AUTO button/Temperature control dial
2. OFF button
3. A/C button
4. CLIMATE button
5. Display screen
6. Air flow control buttons
7. Fan speed control dial
8. Front defroster button
9. Air intake button (Outside air circulation
/Air recirculation
)
10. Rear window defroster button ( ...
IGN off interlock door unlock function does not operate
Diagnosis Procedure
1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT”
1. Select “DOOR LOCK” of “BCM” using CONSULT-III.
2. Select “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT” mode.
3. Check “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT”.
Re ...
Recommended fluids/lubricants and capacities
The following values represent approximate capacities for your Nissan Leaf. Please note that actual refill volumes can vary slightly depending on environmental conditions and service methods. When performing a fluid change, always follow the specific procedures described in the "Do-it-yourself" sect ...
