Nissan Juke Service and Repair Manual : U1010 control unit (can)
Description
Initial diagnosis of combination meter.
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.REPLACE COMBINATION METER
When DTC “U1010” is detected, replace combination meter.
>> INSPECTION END
U1000 can comm circuit
Description
CAN (Controller Area Network) is a serial communication system for real time
application. It is an on-vehicle
multiplex communication system with high data communication speed and exce ...
B2205 vehicle speed
Description
Vehicle speed signal is transmitted from ABS actuator and electric unit
(control unit) via CAN communication
to combination meter.
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedur ...
Other materials:
P160C ECM
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.INSPECTION START
1. Turn ignition switch ON.
2. Erase DTC.
3. Turn ignition switch OFF and wait for 20 seconds.
4. Turn ignition switch ON and perform the self-diagnosis.
Is the DTC P160C displayed again?
YES >> GO TO 2.
NO &g ...
Wiring diagram
DOOR & LOCK SYSTEM
Wiring Diagram
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation
of Option Abbreviation".
...
Final drive
Exploded View
1. Differential side bearing outer race
2. Differential side bearing
3. Final drive
: Replace the parts as a set.
Disassembly
1. Remove differential side bearings, using the drift (A) [SST:
ST33052000] and a puller [Commercial service tool].
Assembly
1. Install different ...
