Nissan Juke Service and Repair Manual : P160C ECM

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Erase DTC.

3. Turn ignition switch OFF and wait for 20 seconds.

4. Turn ignition switch ON and perform the self-diagnosis.

Is the DTC P160C displayed again? YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE ECM

1. Replace ECM.

2. Go to EC-879, "Work Procedure".

>> INSPECTION END

    P1545 EGT sensor 2
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P1545 is displayed with DTC P1544, first perform trouble diagnosis for DTC P1544. Refer to EC-985, "DTC Logic". ...

    P1632 fuel cut off valve
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK FUEL CUT OFF VALVE POWER SUPPLY CIRCUIT FOR OPEN AND SHORT 1. Turn ignition switch OFF. 2. Disconnect fuel cut off valve harness connec ...

    Other materials:

    Radiator core support
    HR16DE HR16DE : Exploded View 1. Radiator core support upper 2. Air guide RH (MT models) 3. Radiator core support lower 4. Air guide LH 5. Air guide (upper) 6. Air guide LH (CVT models) 7. Air guide RH (CVT models) : N·m (kg-m, ft-lb) HR16DE : Removal and Installation RADIATOR CORE ...

    Door lock actuator
    Driver side : Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES &g ...

    S terminal circuit
    Description The output voltage of the alternator is controlled by the IC voltage regulator at the “S” terminal detecting the input voltage. The “S” terminal circuit detects the battery voltage to adjust the alternator output voltage with the IC voltage regulator. Diagnosis Procedu ...