P1544 EGT sensor 2

DTC Logic DTC DETECTION LOGIC NOTE: If DTC P1544 is displayed with DTC P0115, first perform trouble diagnosis for DTC P0115. Refer to EC-907, "DTC Logic". Diagnosis Procedure 1.CHE ...

P160C ECM

DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.INSPECTION START 1. Turn ignition switch ON. 2. Erase DTC. 3. Turn ignition switch OFF and wait for 20 seconds. 4. Turn ignition switch ON ...

Other materials:

Compression pressure
Inspection 1. Warm up engine thoroughly. Then, stop it. 2. Release fuel pressure. Refer to EC-551, "Work Procedure". 3. Remove ignition coil and spark plug from each cylinder. Refer to EM-178, "Exploded View". 4. Connect engine tachometer (not required in use of CONSULT-III ...

HVAC branch line circuit
Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the A/C auto amp. for damage, bend and loose connection (unit side and connector side). Is the inspection result norma ...

Stall test
Inspection and Judgment INSPECTION 1. Inspect the amount of engine oil. Replenish the engine oil if necessary. 2. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80°C (122 to 176°F). Inspect the amount of CVT fluid. Replenish if necessary. 3. Se ...