Nissan Juke Service and Repair Manual : B2205 vehicle speed
Description
Vehicle speed signal is transmitted from ABS actuator and electric unit (control unit) via CAN communication to combination meter.
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.PERFORM SELF-DIAGNOSIS OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
Perform “Self Diagnostic Result” of “ABS”, and repair or replace malfunctioning parts.
>> • Refer to BRC-131, "CONSULT-III Function" (with ESP).
• Refer to BRC-24, "CONSULT-III Function" (without ESP).
U1010 control unit (can)
Description
Initial diagnosis of combination meter.
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.REPLACE COMBINATION METER
When DTC “U1010” is detected, replace combination meter.
...
B2267 engine speed
Description
The engine speed signal is transmitted from ECM to the combination meter via
CAN communication.
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.PERFORM SELF-DIAGNOSIS OF ECM
...
Other materials:
Passenger side door mirror defogger
Description
Heats the heating wire with the power supply from the rear window defogger
relay to prevent the door mirror
from fogging up.
Component Function Check
1.CHECK PASSENGER SIDE DOOR MIRROR DEFOGGER
1. Perform IPDM E/R Active Test (“REAR DEFOGGER”) using CONSULT-III.
2. Touch “O ...
Power supply and ground circuit
Diagnosis Procedure
1.CHECK 4WD CONTROL MODULE POWER SUPPLY (1)
1. Turn the ignition switch OFF.
2. Disconnect 4WD control module harness connector.
3. Check the voltage between 4WD control module harness connector and ground.
4. Turn the ignition switch ON.
CAUTION:
Never start the engin ...
Consult-III/GST checking system
Description
• When CONSULT-III/GST is connected with a data link connector
(A) equipped on the vehicle side, it will communicate with the control
unit equipped in the vehicle and then enable various kinds of
diagnostic tests.
1 : Instrument lower panel RH
• Refer to CONSULT-III Software O ...
