B2267 engine speed

Description The engine speed signal is transmitted from ECM to the combination meter via CAN communication. DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM SELF-DIAGNOSIS OF ECM ...

B2321, B2322 oil level sensor

Description The oil level sensor detects the level of engine oil, and then transmits the oil level signal to the combination meter. DTC Logic DTC DETECTION LOGIC NOTE: When the following con ...

Other materials:

Power supply and ground circuit
A/C auto AMP. : Diagnosis Procedure 1.CHECK SYMPTOM Check symptom (A or B). Which symptom is detected? A >>GO TO 2. B >>GO TO 5. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. Check 10A fuse (No. 3, located in fuse block (J/B)]. NOTE: Refer to PG-22, "Fuse, Connector ...

P0730 incorrect gear ratio
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repair, perform the following procedure to confirm the mal ...

Unit removal and installation
TRANSMISSION ASSEMBLY Exploded View 1. Transaxle assembly A: : For the tightening torque, refer to TM-508, "Removal and Installation". Removal and Installation REMOVAL WARNING: Never open the radiator cap or drain plug when the engine is hot. Hot liquid may spray out, causing s ...