Drive Belt

Exhaust Manifold

Other materials:

Additional service when replacing control unit
ECM ECM : Description Performing the following procedure can automatically activate recommunication of ECM and BCM, but only when the ECM is replaced with a new one*. *: New one means a virgin ECM that has never been energized on-board. (In this step, initialization procedure by CONSULT-I ...

Insufficient cooling
Description Symptom • Insufficient cooling • No cool air comes out. (Air flow volume is normal.) Diagnosis Procedure NOTE: Perform self-diagnoses with CONSULT-III before performing symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis. 1.CHECK MAGNET CLUTCH OPERA ...

System
Relay control system RELAY CONTROL SYSTEM : System Diagram *1: Except for MR16DDT engine models *2: For MR16DDT engine models RELAY CONTROL SYSTEM : System Description IPDM E/R activates the internal control circuit to perform the relay ON-OFF control according to the input signals from va ...