Unit removal and installation

Engine assembly 2WD 2WD : Exploded View 1. Washer 2. Upper torque rod (RH) 3. Engine mounting insulator (RH) 4. Rear torque rod bracket 5. Rear torque rod 6. Engine mounting insulator (L ...

Engine stand setting

Setting NOTE: Explained here is how to disassemble with engine stand supporting transaxle surface. When using different type of engine stand, note with difference in steps and etc. 1. Remove t ...

Other materials:

Combination switch
Exploded View 1. Combination switch 2. Combination switch connector Removal and Installation REMOVAL 1. Remove steering column cover. Refer to IP-13, "Removal and Installation". 2. Remove screws. 3. Disconnect the connector. 4. Pull up the combination switch to remove it. I ...

Commercial Service Tools
HFC-134a (R-134a) Service Tool and Equipment • Never mix HFC-134a (R-134a) refrigerant and/or its specified lubricant with CFC-12 (R-12) refrigerant and/ or its lubricant. • Separate and non-interchangeable service equipment must be used for handling each type of refrigerant/ lubricant. ...

Parking brake switch
Component Function Check 1.CHECK PARKING BRAKE SWITCH OPERATION Operate the parking brake lever. Then check that the brake warning lamp in the combination meter turns ON/ OFF correctly. Is the inspection result normal? YES >> INSPECTION END NO >> Proceed to BRC-70, "Diagno ...