Nissan Juke Service and Repair Manual : Engine unit
Disassembly
1. Remove intake manifold. Refer to EM-28, "Exploded View".
2. Remove catalyst convertor. Refer to EM-33, "2WD : Exploded View" (2WD models) or EM-34, "4WD : Exploded View" (4WD models).
3. Remove turbocharger. Refer to EM-36, "Exploded View".
4. Remove exhaust manifold. Refer to EM-38, "Exploded View".
5. Remove oil pan (lower). Refer to EM-99, "Exploded View".
6. Remove ignition coil, spark plug, and rocker cover. Refer to EM-23, "Exploded View".
7. Remove fuel injector and fuel tube. Refer to EM-47, "Exploded View".
8. Remove timing chain. Refer to EM-67, "Exploded View".
9. Remove camshaft. Refer to EM-78, "Exploded View".
10. Remove water inlet. Refer to CO-24, "Exploded View".
11. Remove water outlet. Refer to CO-26, "Exploded View".
12. Remove cylinder head. Refer to EM-90, "Exploded View".
Assembl
Assemble in the reverse order of disassembly.
Engine stand setting
Setting
NOTE:
Explained here is how to disassemble with engine stand supporting transaxle
surface. When using different
type of engine stand, note with difference in steps and etc.
1. Remove t ...
Drive belt auto tensioner and idler pulley
Exploded View
1. Front cover
2. Drive belt auto-tensioner
: N·m (kg-m, ft-lb)
Removal and Installation
Removal
1. Loosen mounting bolt and remove drive belt auto-tensioner.
Installation
...
Other materials:
Drive belt
Checking Drive Belts
WARNING:
Be sure to perform when the engine is stopped.
1. Inspect belts for cracks, fraying, wear and oil. If necessary,
replace.
2. Evaluate manually if the belt is enough tensioned (tension cannot
be measured by way of frequency meter).
CAUTION:
Auto-tensioner must ...
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front passenger for certain
types of collision. Information necessary to service the system safely is
...
EPS branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the EPS control unit for damage, bend
and loose connection (unit
side and connector side).
Is the inspection result no ...
