Commercial Service Tools

...

Camshaft valve clearance

Inspection and Adjustment INSPECTION Perform inspection as follows after removal, installation or replacement of camshaft or valve-related parts, or if there is unusual engine conditions regardin ...

Other materials:

C1142 press sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CON ...

Component parts
Component Parts Location 1. BCM • With Intelligent Key: Refer to BCS- 6, "BODY CONTROL SYSTEM : Component Parts Location". • Without Intelligent Key: Refer to BCS-96, "BODY CONTROL SYSTEM : Component Parts Location". 2. Magnet clutch 3. Refrigerant pressure sensor ...

B2014 chain of STRG-IMMU
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Lock steering. NOTE: 3. Press the push-button ignition switch. 4. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III. Is DTC detected? YES >> Go to SEC-7 ...