Nissan Juke Service and Repair Manual : Removal and installation
- Engine cover
- Air cleaner and air duct
- Intake manifold
- Charge air cooler
- Catalyst
- Turbocharger
- Exhaust manifold
- Oil pan (lower)
- High pressure fuel pump and fuel hose
- Fuel injector and fuel tube
- Ignition coil, spark plug and rocker cover
Spark plug
Exploded View
1. Rocker cover protector
2. O-ring
3. PCV valve
4. PCV hose
5. Clamp
6. Rocker cover gasket
7. Rocker cover
8. Clamp
9. PCV hose
10. Oil filler cap
11. Spark plug
...
Engine cover
Exploded View
1. Engine cover
2. Mounting rubber
Removal and Installation
REMOVAL
Remove engine cover.
CAUTION:
Never damage or scratch engine cover when installing or removing.
INSTALLA ...
Other materials:
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...
P0962 pressure control solenoid A
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition
switch OFF and wait for at
least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
1. S ...
Symptom diagnosis
COMBINATION SWITCH SYSTEM SYMPTOMS
Symptom Table
1. Perform “Data Monitor” of CONSULT-III to check for any malfunctioning
item.
2. Check the malfunction combinations.
3. Identify the malfunctioning part from the agreed combination and repair or
replace the part.
...