Nissan Juke Owners Manual : Loading tips

•  The GVW must not exceed GVWR or GAWR as specified on the F.M.V.S.S./ C.M.V.S.S. certification label.

• Do not load the front and rear axle to the GAWR. Doing so will exceed the GVWR.

WARNING

•  Properly secure all cargo with ropes or straps to help prevent it from sliding or shifting. Do not place cargo higher than the seatbacks. In a sudden stop or collision, unsecured cargo could cause personal injury.

•  Do not load your vehicle any heavier than the GVWR or the maximum front and rear GAWRs. If you do, parts of your vehicle can break, tire damage could occur, or it can change the way your vehicle handles. This could result in loss of control and cause personal injury.

•  Overloading not only can shorten the life of your vehicle and the tire, but can cause unsafe vehicle handling and longer braking distances. This may cause a premature tire failure, which could result in a serious accident and personal injury.

Failures caused by overloading are not covered by the vehicle’s warranty.

    Vehicle load capacity
    Do not exceed the load limit of your vehicle shown as “The combined weight of occupants and cargo� on the Tire and Loading Information label. Do not exceed the number of occupants shown as “ ...

    Measurement of weights
    Secure loose items to prevent weight shifts that could affect the balance of your vehicle. When the vehicle is loaded, drive to a scale and weigh the front and the rear wheels separately to determ ...

    Other materials:

    Precaution
    Precautions for Suspension • When installing rubber bushings, the final tightening must be carried out under unladen conditions with tires on ground. Spilled oil might shorten the life of rubber bushings. Be sure to wipe off any spilled oil. - Unladen conditions mean that fuel, engine coola ...

    Transmission range switch
    Exploded View 1. Transmission range switch 2. Transaxle assem Removal and Installation REMOVAL 1. Remove battery. Refer to PG-124, "Removal and Installation". 2. Remove transmission range switch connector. 3. Remove control cable. Refer to TM-273, "Removal and Installation&q ...

    Luggage floor trim
    Exploded View 2WD models 1. Rear pillar cap RH 2. Luggage side upper finisher RH 3. Luggage side lower finisher RH 4. Luggage floor board 5. Luggage side upper finisher LH 6. Rear pillar cap LH 7. Luggage side lower finisher LH 8. Seat belt hook LH 9. Shock absorber mask LH 10. Lug ...