Camshaft

Exploded View 1. Camshaft position sensor (PHASE) 2. O-ring 3. Camshaft bracket 4. Camshaft (EXH) 5. Camshaft sprocket (EXH) 6. Camshaft sprocket (INT) 7. Camshaft (INT) 8. Valve lifter ...

Valve oil seal

VALVE OIL SEAL : Removal and Installation REMOVAL 1. Remove camshafts. Refer to EM-78, "Exploded View". 2. Remove valve lifters. Refer to EM-78, "Exploded View". 3. Rotate cran ...

Other materials:

B1186, B1187, B1188, B1189, B1190, B1191 diagnosis sensor unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

Diagnosis system (IPDM E/R)
With intelligent key WITH INTELLIGENT KEY : Diagnosis Description AUTO ACTIVE TEST Description In auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their operation. • Oil pressure warning lamp (only for K9K engine models) • Rear window defogger • F ...

C1176 stop lamp SW2
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT ...