Cylinder Head

VALVE DIMENSIONS VALVE GUIDE VALVE SEAT *1: Diameter made by intersection point of conic angles “α1” and “α2” *2: Diameter made by intersection point of conic angles “α2” ...

Connecting Rod Bearing

CONNECTING ROD BEARING GRADE TABLE UNDERSIZE TABLE CONNECTING ROD BEARING OIL CLEARANCE ...

Other materials:

Blower motor
Diagnosis Procedure 1.CHECK SYMPTOM Check symptom (A or B). Which symptom is detected? A >>GO TO 2. B >>GO TO 7. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. Check 15A fuses (Nos. 14 and 16, located in fuse block (J/B)]. NOTE: Refer to PG-22, "Fuse, Connector and T ...

P2118 throttle control motor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

Inspection
LEVEL • Check that the reservoir tank engine coolant level is within the “MIN” to “MAX” when the engine is cool. A : MAX B : MIN • Adjust the engine coolant level if necessary. LEAKAGE • To check for leakage, apply pressure to the cooling system with the radiator cap tester (commercial ser ...