Nissan Juke Service and Repair Manual : Both side front fog lamps are not turned on

Description

The front fog lamps are not turned ON in any condition.

Diagnosis Procedure

1.CHECK FUSE

Check that the following fuse is fusing.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the applicable circuit. And then replace the fuse.

2.COMBINATION SWITCH INSPECTION

Check combination switch. Refer to BCS-92, "Symptom Table".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning part.

3.CHECK FRONT FOG LAMP REQUEST SIGNAL INPUT

1. Select “FR FOG REQ” of IPDM E/R data monitor item.CONSULT-III DATA MONITOR


1. Select “FR FOG REQ” of IPDM E/R data monitor item.

2. With operating the front fog lamp switch, check the monitor status.

Is the inspection result normal?


Is the inspection result normal? YES >> Replace IPDM E/R.

NO >> Replace BCM. Refer to BCS-93, "Removal and Installation" (with Intelligent Key), BCS-161, "Removal and Installation" (without Intelligent Key).

    Parking, license plate and tail lamps are not turned on
    Without daytime running light system WITHOUT DAYTIME RUNNING LIGHT SYSTEM : Description The parking, license plate, tail lamps and each illumination are not turned ON in any condition. WITHOUT DA ...

    Other materials:

    B27A6, B27A7, B27A8, B27A9 mode door motor
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC is displayed along with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to HAC- 51, "DTC Logic". • If DTC is displayed along with DTC U1010, first perform the trouble diagnosis for DTC U1010. HAC-52, "DTC L ...

    Unlock link function does not operate
    Diagnosis Procedure 1.CHECK DRIVER SIDE OR PASSENGER SIDE DOOR SWITCH Check driver side or passenger side door switch. Refer to DLK-258, "Component Function Check". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace the malfunctioning parts. ...

    U0140 lost communication (BCM)
    Description CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent malfunction detection ability. Many electronic control units are equipped onto a vehicle, and ...