Hazard switch

Component Function Check 1.CHECK HAZARD SWITCH SIGNAL BY CONSULT-III CONSULT-III DATA MONITOR 1. Turn the ignition switch ON. 2. Select “HAZARD SW” of BCM (FLASHER) data monitor item. 3. With ...

Exterior lighting system symptoms

Without daytime running light system WITHOUT DAYTIME RUNNING LIGHT SYSTEM : Symptom Table CAUTION: Perform the self-diagnosis with CONSULT-III before the symptom diagnosis. Perform the trouble di ...

Other materials:

Operation inspection
Work Procedure The purpose of the operational check is to check that the individual system operates normally. Check condition : Engine running at normal operating temperature. 1.CHECK BLOWER MOTOR 1. Operate fan control dial. 2. Check that fan speed changes. Check operation for all fan speeds ...

P0335 CKP sensor (POS)
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or ...

P0340 CMP sensor (phase)
DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0340 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643. Refer to EC-686, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ...