Nissan Juke Service and Repair Manual : Both side headlamps (HI) are not turned on

Description

Both side headlamps (HI) are not turned ON when setting to the lighting switch HI or PASS.

Diagnosis Procedure

1.COMBINATION SWITCH INSPECTION

Check the combination switch. Refer to BCS-92, "Symptom Table".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning part.

2.CHECK HEADLAMP (HI) REQUEST SIGNAL INPUT

1. Select “HL HI REQ” of IPDM E/R data monitor item.CONSULT-III DATA MONITOR


1. Select “HL HI REQ” of IPDM E/R data monitor item.

2. With operating the lighting switch, check the monitor status.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 3.

NO >> Replace BCM. Refer to BCS-93, "Removal and Installation" (with Intelligent Key), BCS-161, "Removal and Installation" (without Intelligent Key).

3.HEADLAMP (HI) CIRCUIT INSPECTION

Check the headlamp (HI) circuit. Refer to EXL-45, "Component Function Check".

Is the inspection result normal? YES >> Replace IPDM E/R.

NO >> Repair or replace the malfunctioning part.

    Exterior lighting system symptoms
    Without daytime running light system WITHOUT DAYTIME RUNNING LIGHT SYSTEM : Symptom Table CAUTION: Perform the self-diagnosis with CONSULT-III before the symptom diagnosis. Perform the trouble di ...

    Both side headlamps (LO) are not turned on
    Description Both side headlamps (LO) are not turned ON in any condition. Diagnosis Procedure 1.CHECK COMBINATION SWITCH Check the combination switch. Refer to BCS-92, "Symptom Table". ...

    Other materials:

    Combination switch input circuit
    Diagnosis Procedure 1.CHECK INPUT 1 - 5 CIRCUIT FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect BCM and combination switch connectors. 3. Check continuity between BCM harness connector and combination switch harness connector. Does continuity exist? YES >> GO TO 2. NO >> ...

    Door does not lock/unlock with door lock and unlock switch
    All door ALL DOOR : Description All doors do not lock/unlock using door lock and unlock switch. ALL DOOR : Diagnosis Procedure 1.CHECK DOOR LOCK AND UNLOCK SWITCH Check door lock and unlock switch. Refer to the following. • Driver side: Refer to DLK-391, "DRIVER SIDE : Component Funct ...

    Road test
    Description DESCRIPTION • The purpose of the test is to determine overall performance of CVT and analyze causes of problems. • The road test consists of the following three parts: 1. “Check Before Engine Is Started” TM-190. 2. “Check at Idle” TM-191. 3. “Cruise Test” TM-192. ...