Nissan Juke Service and Repair Manual : Exterior Lighting System Halogen type
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
- System description
- Component parts
- System
- Diagnosis system (BCM) (with intelligent key system)
- Diagnosis system (BCM) (without intelligent key system)
- Diagnosis system (ipdm e/r) (with intelligent key system)
- Diagnosis system (IPDM E/R) (without intelligent key system)
- Ecu diagnosis informatioN
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- Headlamp (HI) circuit
- Headlamp (LO) circuit
- Headlamp ground circuit
- Daytime running light relay circuit
- Headlamp aiming system (manual)
- Front fog lamp circuit
- Rear fog lamp circuit
- Parking lamp circuit
- Tail lamp circuit
- License plate lamp circuit
- Light & rain sensor
- Turn signal lamp circuit
- Hazard switch
- Symptom diagnosis
- Exterior lighting system symptoms
- Both side headlamps (HI) are not turned on
- Both side headlamps (LO) are not turned on
- Parking, license plate and tail lamps are not turned on
- Both side front fog lamps are not turned on
- Periodic maintenance
- Removal and installation
- Headlamp
- Front combination lamp
- Front fog lamp
- Light & rain sensor
- Lighting & turn signal switch
- Hazard switch
- Side turn signal lamp
- Headlamp aiming switch
- Rear combination lamp
- High-mounted stop lamp
- License plate lamp
- Rear fog lamp
- Service data and specifications (SDS)
Door mirror remote control switch
Exploded View
1. Instrument lower panel
2. Switch bracket
3. Door mirror remote control switch
Removal and Installation
REMOVAL
1. Remove the instrument lower panel. Refer to IP-13, "Re ...
Precaution
...
Other materials:
Precautions on cruise control
RES+ switch
CANCEL switch
SET- switch
Cruise control switch
If the cruise control system detects an internal fault or operational anomaly, it will deactivate automatically to maintain vehicle safety. The dedicated cruise ...
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always us ...
Camshaft valve clearance
Inspection and Adjustment
INSPECTION
Perform inspection as follows after removal, installation or replacement of
camshaft or valve-related parts, or if
there is unusual engine conditions regarding valve clearance.
1. Remove rocker cover. Refer to EM-53, "Exploded View".
2. Measure ...
