Diagnosis system (IPDM E/R) (without intelligent key system)

Diagnosis Description AUTO ACTIVE TEST Description In auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their operation. • Oil pressure warning lamp ...

Wiring diagram

EXTERIOR LIGHTING SYSTEM Wiring Diagram For connector terminal arrangemants, harness layouts, and alphabets in a (option abbreviation: if not described in wiring diagram), refer to GI-12, "Co ...

Other materials:

U1010 control unit (CAN)
Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent malfunction detection ability. Many electronic control units are equipped onto a vehicle, and ...

Throttle valve closed position learning
Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time harness connector of electric throttle control actuator or ECM is disconne ...

L terminal circuit (open)
Description The “L” terminal circuit controls the charge warning lamp. The charge warning lamp illuminates when the ignition switch is set to ON or START. When the alternator is providing sufficient voltage with the engine running, the charge warning lamp will go off. If the charge warnin ...