Nissan Juke Owners Manual : Tire equipment

SUMMER tires have a tread designed to provide superior performance on dry pavement. However, the performance of these tires will be substantially reduced in snowy and icy conditions.

If you operate your vehicle on snowy or icy roads, NISSAN recommends the use of MUD & SNOW or ALL SEASON tires on all four wheels.

Consult a NISSAN dealer for the tire type, size, speed rating and availability information.

For additional traction on icy roads, studded tires may be used. However, some U.S. states and Canadian provinces prohibit their use.

Check local, state and provincial laws before installing studded tires.

Skid and traction capabilities of studded snow tires, on wet or dry surfaces, may be poorer than that of non-studded snow tires.

Tire chains may be used. For details, see “Tire chains”  of this manual.

All-Wheel Drive (AWD) model

If you install snow tires, they must also be the same size, brand, construction and tread pattern on all four wheels.

    Draining of coolant water
    If the vehicle is to be left outside without antifreeze, drain the cooling system, including the engine block. Refill before operating the vehicle. For details, see “Engine cooling system” . ...

    Special winter equipment
    It is recommended that the following items be carried in the vehicle during winter: •  A scraper and stiff-bristled brush to remove ice and snow from the windows and wiper blades. • A sturdy, ...

    Other materials:

    Fuel pressure control
    Fuel pressure control : System Diagram Fuel pressure controlL : System Description INPUT/OUTPUT SIGNAL CHART *: ECM determines the start signal status by the engine speed signal and battery voltage. CVT models System Description Low fuel pressure control • The low fuel pressure pump i ...

    Unit removal and installation
    Transaxle assembly MR16DDT : Exploded View 1. Transaxle assembly : Refer to "INSTALLATION" in TM-84, "MR16DDT : Removal and Installation" for the locations and tightening torque. MR16DDT : Removal and Installation CAUTION: Never reuse CSC (Concentric Slave Cylinder). ...

    A/C on signal
    Component Function Check 1.CHECK A/C ON SIGNAL With CONSULT-III 1. Turn ignition switch ON. 2. Operate blower motor. 3. Select “AIR CONDITIONER” of “BCM” using CONSULT-III. 4. Select “AIR COND SW” in “DATA MONITOR” mode. 5. Check A/C ON signal when the A/C switch is operated. Is the inspec ...