Nissan Juke Service and Repair Manual : Lighting & turn signal switch

Removal and Installation

REMOVAL

Remove light & turn signal switch. Refer to BCS-94, "Removal and Installation".

INSTALLATION

Install in the reverse order of removal.

    Light & rain sensor
    Exploded View CAUTION: When the light & rain sensor is removed from windshield, the light & rain sensor cannot be re-used. REMOVAL 1. Light & rain sensor bracket 2. Mirror base ...

    Hazard switch
    Exploded View 1. Instrument panel assembly 2. Hazard switch : Pawl Removal and Installation REMOVAL 1. Remove Audio unit. Refer to AV-38, "Removal and Installation". 2. Disengage f ...

    Other materials:

    Hood lock
    Exploded View 1. Hood lock control cable assembly 2. Hood lock assembly : Clip : N·m (kg-m, ft-lb) : Body grease Hood lock HOOD LOCK : Removal and Installation REMOVAL 1. Remove front center grille. Refer to EXT-18, "Removal and Installation". 2. Remove crash zone sensor. Ref ...

    Mainshaft and gear
    Exploded View 1. Mainshaft front bearing outer race 2. Mainshaft front bearing inner race 3. Mainshaft 4. 1st main gear 5. 1st inner baulk ring 6. 1st synchronizer cone 7. 1st outer baulk ring 8. Spread spring 9. 1st-2nd synchronizer hub 10. 1st-2nd coupling sleeve 11. 2nd outer ...

    P0500 VSS
    Description The vehicle speed signal is sent to the combination meter from the “ABS actuator and electric unit (control unit)” by CAN communication line. The combination meter then sends a signal to the ECM by CAN communication line. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P050 ...