Front fog lamp aiming adjustment

Description PREPARATION BEFORE ADJUSTING NOTE: For details, refer to the regulations in your own country. Before performing aiming adjustment, check the following. • Adjust the tire pressur ...

Headlamp

Exploded View REMOVAL 1. Headlamp assembly 2. EPT sealer [2.8 mm (0.110 in)] : Do not reuse : N·m (kg-m, in-lb) DISASSEMBLY 1. Back cover 2. Halogen bulb 3. Headlamp housing assembly ...

Other materials:

Avoiding collision and rollover
WARNING Failure to operate this vehicle in a safe, alert, and prudent manner significantly increases the risk of a dangerous situation and may result in an immediate loss of control or a severe accident. Be alert, anticipate potential hazards, and drive defensively at all times behind the ...

Door request switch
Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “REQ SW-DR”, “REQ SW-AS” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result norma ...

P0826 up and down shift SW
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. After the repai ...