Nissan Juke Service and Repair Manual : DTC/circuit diagnosis
- Headlamp (HI) circuit
- Headlamp (LO) circuit
- Headlamp ground circuit
- Daytime running light relay circuit
- Headlamp aiming system (manual)
- Front fog lamp circuit
- Rear fog lamp circuit
- Parking lamp circuit
- Tail lamp circuit
- License plate lamp circuit
- Light & rain sensor
- Turn signal lamp circuit
- Hazard switch
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.INTERVIEW FOR MALFUNCTION
Interview the symptom to the customer.
>> GO TO 2.
2.SYMPTOM CHECK
Check the sympto ...
Headlamp (HI) circuit
Component Function Check
1.CHECK HEADLAMP (HI) OPERATION
CONSULT-III ACTIVE TEST
1. Select “EXTERNAL LAMPS” of IPDM E/R active test item.
2. With operating the test items, check that the headlamp ...
Other materials:
Preparation
Special Service Tools
BASIC INSPECTION
STEERING WHEEL
Inspection
NEUTRAL POSITION STEERING WHEEL
1. Make sure that steering gear assembly, steering column assembly and
steering wheel are installed in the
correct position.
2. Perform neutral position inspection after wheel alignment. Refer ...
Precaution
Service Notice or Precautions for Rear Final Drive
• Check for the correct installation status prior to removal or disassembly.
If matching marks are required, be
certain they do not interfere with the function of the parts when applied.
• Overhaul should be done in a clean work area, it is pre ...
B1138, B1139, B1140, B1141, B1142, B1143 diagnosis sensor unit
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
