Nissan Juke Service and Repair Manual : Air breather hose

Removal and Installation

REMOVAL

1. Remove air cleaner case. Refer to EM-26, "Removal and Installation".

2. Remove clip from bracket.

3. Remove air breather hose from transaxle assembly.

INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION:
Check air breather hose not collapsed or blocked due to folding or bending when installed.

• Install air breather hose to air breather tube so that the paint mark (A) faces upward. Also insert hose to the bend of air breather tube.

G sensor


    TCM
    Exploded View 1. Bracket 2. TCM :Vehicle front : N·m (kg-m, in-lb) Removal and Installation NOTE: When replacing TCM and transaxle assembly as a set, replace transaxle assembly first and ...

    G sensor
    Exploded View 1. G sensor : Vehicle front : N·m (kg-m, in-lb) Removal and Installation CAUTION: • Never drop or strike G sensor, because it has little tolerance for impact. • Never use a ...

    Other materials:

    Exploded View
    1. Final drive mounting bracket 2. Washer 3. Rear final drive assembly : Vehicle front : N·m (kg-m, ft-lb) : Never reuse parts : Apply multi purpose grease : Apply gear oil. ...

    P0720 output speed sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repai ...

    Door mirror defogger
    Description Heats the heating wire with the power supply from the rear window defogger relay to prevent the door mirror from fogging up. Component Function Check 1.CHECK DOOR MIRROR DEFOGGER 1. Perform IPDM E/R Active Test (“REAR DEFOGGER”) using CONSULT-III. 2. Touch “ON”. 3. Check ...