Nissan Juke Service and Repair Manual : Security Control System without intelligent key system
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution for Procedure without Cowl Top Cover
- Precaution for Battery Service
- System description
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosiS
- P1610 lock mode
- P1611 ID discord, IMMU-ECM
- P1612 chain of ECM-IMMU
- P1614 chain of IMMU-KEY
- P1615 diffrence of key
- P1616 ECM
- B2190 nats antenna AMP
- B2191 difference of key
- B2192 ID discord, IMMU-ECM
- B2193 chain of ECM-IMMU
- B2195 anti-scanning
- B2196 dongle unit
- B209f cranking request circuit
- B20A0 cranking request circuit
- B210B starter control relay
- B210C starter control relay
- B210D starter relay
- B210E starter relay
- Hood switch
- Horn function
- Security indicator lamp
- Symptom diagnosis
- Security indicator lamp does not turn on or blink
- Vehicle security system cannot be set
- Vehicle security alarm does not activate
- Removal and installation
Push-button ignition switch
Removal and Installation
REMOVAL
1. Remove the NATS antenna amp. Refer to SEC-167, "Removal and
Installation".
2. Remove the push-button ignition switch.
1. Disengage the push-button ...
Precaution
...
Other materials:
On board diagnostic (OBD) system
Description
This is an onboard diagnosis system which records diagnosis information
related to the exhaust gases. It
detects malfunctions related to sensors and actuators. The malfunctions are
indicated by means of the malfunction
indicator lamp (MIL) and are stored as DTC in the ECU memory. ...
Cylinder Block
AVAILABLE PISTON
PISTON RING
PISTON PIN
CONNECTING ROD
*: After installing in connecting rod
CRANKSHAFT
*: Total indicator reading ...
Removal and Disassembly
• When instructed to use SST, use specified tools. Always be careful to work
safely, avoid forceful or uninstructed
operations.
• Exercise maximum care to avoid damage to mating or sliding surfaces.
• Dowel pins are used for several parts alignment. When replacing and
reassembling parts ...
