Security indicator lamp

Component Function Check 1.CHECK FUNCTION 1. Perform “THEFT IND” in the “ACTIVE TEST” mode of “BCM” using CONSULT-III. 2. Check security indicator lamp operation. Is the inspection ...

Security indicator lamp does not turn on or blink

Description Security indicator lamp does not blink when ignition switch is in a position other than ON. NOTE: • Before performing the diagnosis, check “Work Flow”. Refer to SEC-187, " ...

Other materials:

P0710 transmission fluid temperature sensor A
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repai ...

BCM
Removal and Installation CAUTION: Before replacing BCM, perform “READ CONFIGURATION” to save or print current vehicle specification. Refer to BCS-80, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Description". REMOVAL (RHD MODELS) 1. Remove glove box assembly. Refer ...

Component parts
CVT control system : Component Parts Location 1. Multi display unit (MDU)* Refer to DMS-3, "Component Parts Location". 2. Combination meter 3. S mode indicator (On the combination meter) 4. Shift position indicator (On the combination meter) 5. Malfunction indicator lamp (MIL) ( ...