Nissan Juke Service and Repair Manual : Vehicle security alarm does not activate

Description

Alarm does not operate when alarm operating condition is satisfied.

NOTE

:
Check that vehicle is under the condition shown in “CONDITIONS OF VEHICLE (OPERATING CONDITIONS)” before starting diagnosis, and check each symptom.

CONDITION OF VEHICLE (OPERATING CONDITIONS)

“SECURITY ALARM SET”: ON

Check the setting of “SECURITY ALARM SET” in “Work Support” mode of “THEFT ALM” of “BCM” using CONSULT-III.

Diagnosis Procedure

1.CHECK DOOR SWITCH

Check door switch.

Refer to DLK-397, "Component Function Check" (With super lock) or DLK-522, "Component Function Check" (Without super lock).

Is the inspection result normal? YES >> GO TO 2.

NO >> Replace the malfunctioning door switch 2.CHECK HOOD SWITCH

Check hood switch.

Refer to SEC-223, "Component Function Check".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace hood switch.

3.CHECK HAZARD WARNING LAMPS

Check hazard warning lamps.

Refer to EXL-69, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace malfunctioning parts.

4.CHECK HORN FUNCTION

Check horn function.

Refer to SEC-225, "Component Function Check".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace the malfunctioning parts.

5.CONFIRM THE OPERATION

Confirm the operation again.

Is the result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> GO TO 1.

    Vehicle security system cannot be set
    Key fob KEY FOB : Description Armed phase is not activated when door is locked using keyfob. NOTE: Check that vehicle is under the condition shown in “CONDITIONS OF VEHICLE (OPERATING CONDITIO ...

    Removal and installation
    NATS ANTENNA AMP. Removal and Installation REMOVAL 1. Remove the steering column cover. Refer to IP-13, "Removal and Installation". 2. Remove the NATS antenna amp. mounting screw, and ...

    Other materials:

    ACC warning does not operate
    Diagnosis Procedure 1.CHECK COMBINATION METER BUZZER Check combination meter buzzer. Refer to WCS-40, "Component Function Check". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace the malfunctioning parts. 2.REPLACE BCM 1. Replace BCM. Ref ...

    P0097, P0098 IAT sensor 2
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

    B2192 ID discord, IMMU-ECM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III. Is DTC detected? YES >> Go to SEC-60, "Diagnosis Procedure". NO >> I ...