Nissan Juke Service and Repair Manual : Removal and installation
NATS ANTENNA AMP.
Removal and Installation
REMOVAL
1. Remove the steering column cover.
Refer to IP-13, "Removal and Installation".
2. Remove the NATS antenna amp. mounting screw, and then remove NATS antenna amp. from steering lock assembly.
INSTALLATION
Install in the reverse order of removal.
Vehicle security alarm does not activate
Description
Alarm does not operate when alarm operating condition is satisfied.
NOTE:
Check that vehicle is under the condition shown in “CONDITIONS OF VEHICLE
(OPERATING CONDITIONS)”
befo ...
Other materials:
B2555 stop lamp
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Depress the brake pedal and wait 1 second or more.
2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected?
YES >> Go to SEC-73, "Diagnosis ...
Wheel sensor
Front wheel sensor : Exploded View
1. Front LH wheel sensor
2. Front LH wheel sensor harness connector
: Vehicle front
: N·m (kg-m, in-lb)
NOTE:
Front RH wheel sensor is symmetrically opposite of LH.
Front wheel sensor : Removal and Installat
REMOVAL
1. Remove tires.
2. Remove the fend ...
Emission control system warranty
Your NISSAN is covered by the following emission warranties.
For USA:
• Emission Defects Warranty
• Emissions Performance Warranty
Details of these warranties may be found with other vehicle warranties in your
Warranty Information Booklet which comes with your NISSAN. If you di ...
