Nissan Juke Service and Repair Manual : P1616 ECM

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION

1. Turn ignition switch ON amd wait 2 seconds or more.

2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III.

Is DTC detected? YES >> Go to SEC-199, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Select “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC CONFIRMATION PROCEDURE for DTC P1616. Refer to SEC-199, "DTC Logic".

Is DTC P1616 displayed again? YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE ECM

Replace ECM.

>> INSPECTION END

    P1615 diffrence of key
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using ...

    B2190 nats antenna AMP
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CO ...

    Other materials:

    Garage Jack and Safety Stand and 2-Pole Lift
    WARNING: • Park the vehicle on a level surface when using the jack. Check to avoid damaging pipes, tubes, etc. under the vehicle. • Never get under the vehicle while it is supported only by the jack. Always use safety stands when you have to get under the vehicle. • Place wheel choc ...

    Precaution Necessary for Steering Wheel Rotation after Battery Dis
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...

    Overspeed at idle speed or on releasing brake
    Description CHART 14: OVERSPEED AT IDLE SPEED OR ON RELEASING BRAKE Diagnosis Procedure 1.CHECK ENGINE OIL Check the grade of engine oil. Refer to LU-33, "Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Replace engine oil. Refer to LU-34, "Re ...