Nissan Juke Service and Repair Manual : DTC/circuit diagnosiS

Additional service when replacing control unit
ECM ECM : Description Performing the following procedure can automatically activate recommunication of ECM and BCM, but only when the ECM is replaced with a new one*. *: New one means a virgin ...

P1610 lock mode
Description ECM forcibly switches to the mode that inhibits engine start, when engine start operation is performed 5 times or more while communication between ECM and BCM is not normal, or when en ...

Other materials:

Precaution for Brake System
WARNING: Clean any dust from the front brake and rear brake with a vacuum dust collector. Never blow with compressed air. • Brake fluid use refer to MA-13, "Fluids and Lubricants". • Never reuse drained brake fluid. • Never spill or splash brake fluid on painted surfaces. Brak ...

P1612 chain of ECM-IMMU
DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P1612 is displayed with DTC U1000 (for BCM), first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC P1612 is displayed with DTC U1010 (for BCM), first perform the trouble diagnosis for DTC U101 ...

Camshaft
*: Total indicator reading Valve Lifter Valve Clearance *:Approximately 80°C (176°F) Available Valve Lifter ...