Nissan Juke Service and Repair Manual : P1611 ID discord, IMMU-ECM

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III.

Is DTC detected? YES >> Refer to SEC-193, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM INITIALIZATION

Perform initialization of BCM and reregistration of all ignition keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

Can the system be initialized and can the engine be started with reregistered ignition key? YES >> INSPECTION END

NO >> GO TO 2.

2.CHECK SELF DIAGNOSTIC RESULT

1. Select “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III.

2. Erase DTC.

3. Perform DTC CONFIRMATION PROCEDURE for DTC P1611. Refer to SEC-193, "DTC Logic".

Is DTC detected? YES >> GO TO 3.

NO >> INSPECTION END

3.REPLACE BCM

1. Replace BCM. Refer to BCS-161, "Removal and Installation".

2. Perform initialization of BCM and reregistration of all ignition keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

Can the system be initialized and can the engine be started with reregistered ignition key? YES >> INSPECTION END

NO >> GO TO 4.

4.REPLACE ECM

Replace ECM.

Refer to EC-447, "Removal and Installation" (MR16DDT), or EC-805, "Removal and Installation" (HR16DE).

>> INSPECTION END

    P1610 lock mode
    Description ECM forcibly switches to the mode that inhibits engine start, when engine start operation is performed 5 times or more while communication between ECM and BCM is not normal, or when en ...

    P1612 chain of ECM-IMMU
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P1612 is displayed with DTC U1000 (for BCM), first perform the trouble diagnosis for DTC U1000. Refer to BCS-153, "DTC Logic". • If ...

    Other materials:

    Recommended fluids and lubricants
    Fluids and Lubricants *1: For additional information, see “SAE Viscosity Number”. *2: Use Genuine NISSAN Engine Coolant or equivalent in its quality, in order to avoid possible aluminium corrosion within the engine cooling system caused by the use of non-genuine engine coolant. Note that ...

    I-BSI system limitations
    WARNING The following points outline critical operational limitations for the Intelligent Blind Spot Intervention (I-BSI) system. Failing to operate your Nissan Leaf in strict accordance with these limitations could result in an inappropriate system response, potentially leading to serious inju ...

    ABS warning lamp
    Component Function Check 1.CHECK ABS WARNING LAMP FUNCTION Check that ABS warning lamp in combination meter turns ON for approx. 1 second after ignition switch is turned ON. CAUTION: Never start engine. Is the inspection result normal? YES >> INSPECTION END NO >> Proceed to B ...