Nissan Juke Service and Repair Manual : P1610 lock mode

Description

ECM forcibly switches to the mode that inhibits engine start, when engine start operation is performed 5 times or more while communication between ECM and BCM is not normal, or when engine start operation is performed 5 times or more using the unregistered ignition key.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III.

Is DTC detected? YES >> Refer to SEC-192, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK ENGINE START FUNCTION

1. Perform the check for DTC except DTC P1610.

2. Use CONSULT-III to erase DTC after fixing.

3. Turn ignition switch OFF.

4. Turn ignition switch ON using the registered ignition key and wait for 5 seconds.

5. Turn the ignition switch OFF and wait 5 seconds.

6. Repeat steps 4 and 5 twice (a total of 3 times).

7. Check that engine can start using the registered ignition key.

>> INSPECTION END

    P1611 ID discord, IMMU-ECM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using ...

    Other materials:

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...

    Back door request switch
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “REQ SW-BD/TR” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >&g ...

    Radiator
    Exploded View 1. Cooling fan assembly 2. Mounting rubber (upper) 3. Radiator 4. Mounting rubber (lower) 5. O-ring 6. Drain plug 7. Clamp 8. Radiator hose (lower) (LH) 9. Reservoir tank hose 10. Reservoir tank 11. Reservoir tank cap 12. Clamp 13. Radiator hose (upper) 14. Water ...