Nissan Juke Service and Repair Manual : Idle speed

Description

This describes how to check the idle speed. For the actual procedure, follow the instructions in “BASIC INSPECTION”.

Special Repair Requirement

1.CHECK IDLE SPEED

Check idle speed in “DATA MONITOR” mode with CONSULT-III.With CONSULT-III


Check idle speed in “DATA MONITOR” mode with CONSULT-III.

Check idle speed with Service $01 of GST. With GST


Check idle speed with Service $01 of GST.

>> INSPECTION END

    Ignition timing
    Description This describes how to check the ignition timing. For the actual procedure, follow the instructions in “BASIC INSPECTION”. Special Repair Requirement 1.CHECK IGNITION TIMING 1. A ...

    Other materials:

    Removal and installation
    IPDM E/R Exploded View 1. IPDM E/R cover A 2. IPDM E/R 3. IPDM E/R cover B Removal and Installation IPDM E/R integrated relays are not serviceable parts, and must not be removed from the unit. REMOVAL 1. Remove battery. 2. Press and expand pawls (A) on lateral side of IPDM E/R cover ...

    P1614 chain of IMMU-KEY
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III. Is DTC detected? YES >> Refer to SEC-195, "Diagnosis Procedure". ...

    Insufficient cooling
    Description Symptom • Insufficient cooling • No cool air comes out. (Air flow volume is normal.) Diagnosis Procedure NOTE: Perform self-diagnosis with CONSULT-III before performing symptom diagnosis. If any malfunction result or DTC is detected, perform the corresponding diagnosis. 1 ...