Nissan Juke Owners Manual : Changing engine coolant

Major cooling system repairs should be performed by a NISSAN dealer. The service procedures can be found in the appropriate NISSAN Service Manual.

Improper servicing can result in reduced heater performance and engine overheating.

WARNING

• To avoid the danger of being scalded, never change the coolant when the engine is hot.

•  Never remove the radiator cap when the engine is hot. Serious burns could be caused by high pressure fluid escaping from the radiator.

• Avoid direct skin contact with used coolant. If skin contact is made, wash thoroughly with soap or hand cleaner as soon as possible.

• Keep coolant out of reach of children and pets.

Engine coolant must be disposed of properly.

Check your local regulations.

    Checking engine coolant level
    Check the coolant level in the reservoir when the engine is cold. If the coolant level is below the MIN level 2 , open the reservoir cap and add coolant up to the MAX level 1 . If the reservoir ...

    Other materials:

    P062f eeprom
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION 1. S ...

    Component parts
    Component Part Location 1. BCM Refer to BCS-161, "Removal and Installation". 2. Heater control 3. Blower fan resistor 4. Blower motor A. Left side of heater unit assembly B. Right side of heater unit assembly Component Description Heater and ventilation unit assembly : Blowe ...

    Turbocharger boost control
    Turbocharger boost control : SystemDiagram Turbocharger boost control : System Description INPUT/OUTPUT SIGNAL CHART SYSTEM DESCRIPTION Depending on driving conditions, the ECM performs ON/OFF duty control of the turbocharger boost control solenoid valve and controls the boost by adjustin ...