Changing engine coolant

Major cooling system repairs should be performed by a NISSAN dealer. The service procedures can be found in the appropriate NISSAN Service Manual. Improper servicing can result in reduced heater pe ...

Checking engine oil level

1. Park the vehicle on a level surface and apply the parking brake. 2. Run the engine until it reaches operating temperature. 3. Turn off the engine. Wait more than 10 minutes for the oil to drain ...

Other materials:

C1109 power and ground system
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT ...

Oil pan
Exploded View 1. Baffle plate 2. Gasket 3. Oil pan 4. O-ring 5. Drain plug 6. Oil level gauge guide 7. Transaxle 8. Crankshaft position sensor (POS) : N·m (kg-m, ft-lb) : N·m (kg-m, in-lb) : Always replace after every disassembly. Removal and Installation REMOVAL CAUTION: Nev ...

Combination switch
Exploded View 1. Combination switch 2. Combination switch connector Removal and Installation REMOVAL 1. Remove steering column cover. Refer to IP-13, "Removal and Installation". 2. Remove screws. 3. Disconnect the connector. 4. Pull up the combination switch to remove it. I ...